Install Instructions for DUAL or Single 50″ light bars with Offroad LED Bars custom mounts

Here is a step by step manual for installing your DUAL or Single Offroad LED Bars 50″ light bars with their custom 50″ light bar roof mounts. These mounts attached inside the door jams behind the rubber seal, concealing the mounting holes and hardware. Mounts can be used for straight or curved LED light bars. […]

 

Our LED bars vs. the “typical eBay” bars

We often are asked why people would buy our bars vs. the typical ones on eBay for less money. Here are some very specific reasons you want to buy from us and use our product: The Typical import light. Key differences are: 1) Standard 1year warranty. We do lifetime 2) pulls 16amps at only 12 […]

 

20″ (OLB) Off Road LED light bar Review – Reviewer: Team Stance Sponsored Crew – A.J. Logan

Product is the 20″ Offroad LED Bars (OLB) 20″ LED light bar. To Purchase —> 20″ light bar for sale Pros -Everything is included with the kit -Wiring harness is complete and good quality -Wiring harness includes the switch -Wiring harness has plenty of wire (length) for almost any application -Complete bolt on kit -Light […]

 

Custom Paint and Halo Headlights Review – Reviewer: Team Stance Sponsored Crew – A.J. Logan

Product is the painted inner housings with custom installed Prestige color changing halos. Gold Standard Lighting did all the work using Prestige products for lighting. To order this paint and Halo install service —> Custom Paint and Halo Service Pros -Paint scheme was what I asked for -Clean paint job (no runs or splotches) -Halos […]

 

Install Instructions for 50″ light bar with Offroad LED Bars custom mounts

Here is a step by step manual for installing your DUAL or Single Offroad LED Bars 50″ light bars with their custom 50″ light bar roof mounts. These mounts attached inside the door jams behind the rubber seal, concealing the mounting holes and hardware. Mounts can be used for straight or curved LED light bars. […]

 

Q: Can I wire multiple LED lights together with single harness?

A: Yes, lights need to be wired in parallel. Which means positives together and negatives together. Each harness is able to handle 300 Watts, simply add the wattage of each bar and do not exceed this limit.

 

Those Fender Bolts though!! – throw back post

WE DON’T RECOMMEND DOING THIS! WE DON’T RECOMMEND DOING THIS! WE DON’T RECOMMEND DOING THIS! IT IS A PERMANENT MODIFICATION TO YOUR VERY EXPENSIVE TRUCK AND RESALE COULD GO TO $0.00!! We get a lot of questions about those big ole’ bolts in our fenders so we figured it’s time to give a little detail. […]

 

Eclipse

Thank you for using Eclipse.

We designed Eclipse to be as user friendly as possible, but if you do run into trouble we provide a support forum, and precise documentation.

WordPress

Home 2013

We offer financingFacebook reviews